Xsens

Motion Capturing with Xsens

_

_

So far we're providing two suits with the case

Case and Content

The case contains everything you need to capture full body performances. Additional to that there are two suits.

The Sensors

There should be 18 sensors in the case. These 17 are essential to get the capturing process started at all:

From Left to right: upper body sensors, upper body cable whip, lower body sensors, lower body cable whip, prop, cable whip to connect prop in conjunction with a body part.

Upper Body

• 1 x Head
• 1 x Stern
• 3 x Left Shoulder
• 1 x Left Hand
• 3 x Right Shoulder
• 1 x Right Hand

Lower Body

• 1 x Pelvis
• 3 x Right Leg
• 3 x Left Leg

There is an additional sensor for a potential Prop.

The Sensors are connected to cable whips that should be contained in the same bag as the sensors.

The Bodypack

The whips are then connected to the bodypack. The bodypack is a small computer that processes the information provided by the sensors.

The Battery

The battery, if properly charged, provides the bodypack with energy. The battery comes with a wrapper, a cable to connect it to the bodypack and a charger.

The Router

The router is connected to a PC with an Ethernet Cable and sends the information it receives from the bodypack to the Xsens Mvn Software.

The Dongle

The dongle is an authentification device that needs to be plugged into the PC to get the Xsens software running.

Dressing up

Using the right dimensions

This is how you put on the lycra suit.

So far we're offering two suits. L (1.60-1.75) and XL (1.75-1.85). You shouldn't put it on if you're larger than that.

Washing the suit

Due to hygienic reasons you must always wash the suit after using it. Remove all cables, Bodypack and Motiontrackers. Follow the instructions on the label inside the suit:

• Only Synthetic machine wash at 30°C!!!
• Do not bleach
• Do not iron
• Do not dry clean
• Do not tumble dry
• For the headband, gloves and straps use only cold hand wash.

Wiring things up

You can follow this instructional video to wire up the suit. Always have a second person to help you set things up.

Xsens Mvn FullBody Software

There is a lot of information about the Software and how to use it on their support page.

Installing the Software

Download MVN Analyze/Animate here.

Running the Software

As you start the software it will ask you to insert the dongle.

Are you trying to run the sofware without a dongle?

If you open the Xsens Full Body Motion Suit Box, you'll find the dongle right next to the bodypack.

here is where the dongle should always be, when the suit is rented